Siemens WM..T SERIES 사용 설명서 및 설치 지침 - 페이지 35

{카테고리_이름} Siemens WM..T SERIES에 대한 사용 설명서 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens WM..T SERIES 40 페이지.

페이지 인쇄

Display

. of the 'Ready in' time

lights up

Other displays

Faults and what to do about them.

Faults

Water is leaking from the

machine.

The machine is not filling

with water.

Detergent is not being dis-

pensed.

The door cannot be

opened.

The program will not

start.

The drum briefly jerks or

judders after the program

has started.

The water is not draining.

Water is not visible in the

drum.

The spin result is not sat-

isfactory.

Laundry is wet/too damp.

The spin cycle runs sev-

eral times.

Cause/Remedy

Undervoltage in the wash programme. The programme is extended. ~ Page 29

Switch off the appliance, wait for five seconds and then switch it on again. If the dis-

play appears again, call customer services. ~ Page 37

Cause/Remedy

Attach the drain hose correctly or replace it.

■

Tighten the screw connection of the drain hose.

■

Have you pressed the ‹ button?

■

Is the tap turned on?

■

Could the filter be clogged? Clean the filter. ~ Page 32

■

Note:

If an additional water filter has been installed (depending on model),

check for contaminants and clean if required ~ separate installation and

cleaning instruction for water filter.

Is the supply hose kinked or trapped?

■

The safety function is activated.

■

For safety reasons, the washing machine door remains locked when

Note:

the water level or temperature is high (See ~ Cancel the programme

~ Page 27) or while the drum is rotating.

Is - - - - selected (Rinse Stop = no final spin, water level is high)?

■

~ Page 27

Can the door only be opened by the emergency release? ~ Page 33

■

Have you pressed the ‹ or Finished in-time button?

■

Is the door closed?

■

Is the w childproof lock activated? Deactivate. ~ Page 26

■

Not a fault – the internal motor test may cause the drum to jerk or judder briefly

when the wash program starts.

Is - - - - selected (Rinse Stop = no final spin)? ~ Page 27

■

Clean the drain pump. ~ Page 31

■

Clean the drain pipe and/or the drain hose. ~ Page 32

■

Not a fault – the water is below the visible area.

Not a fault – the unbalanced load detection system has interrupted the spin

■

cycle because the laundry is unevenly distributed.

Distribute small and large items of laundry evenly in the drum.

Less iron (depending on the model) selected? ~ Page 23

■

Is the selected speed too low?

■

You may run the program Spin/Drain to spin the laundry again.

■

Not a fault – the unbalanced load detection system is adjusting an imbalance.

Faults and what to do about them