Epson AP-60 - Projector Sound Solution 사용자 설명서 - 페이지 21
{카테고리_이름} Epson AP-60 - Projector Sound Solution에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson AP-60 - Projector Sound Solution 28 페이지. Projector sound solution
Epson AP-60 - Projector Sound Solution에 대해서도 마찬가지입니다: 매뉴얼 (5 페이지), 설치 매뉴얼 (28 페이지), 연결 매뉴얼 (1 페이지), 부품 목록 (1 페이지), 브로셔 및 사양 (4 페이지), 제품 지원 게시판 (8 페이지)
페이지 인쇄
Problems Using the Pendant Microphone
Problem
The power light won't come on.
There is no sound.
My voice isn't loud enough.
External audio devices are too
loud
Problems Using the Remote Control
Problem
The system doesn't respond to
the remote control.
The remote control has been lost
or damaged.
Solution
You may need to replace the pendant microphone's batteries (see page 19).
Check to make sure that the pendant microphone's power button is green. If it's red
or not illuminated, replace the batteries (see page 19).
Make sure the AP-60 is turned on. If the AP-60 doesn't receive an audio signal for 60
minutes, it turns off automatically.
Press the Mute button on the remote control to make sure the sound wasn't muted
or turned off.
Try increasing the volume.
Use the Gain control wheel on the pendant microphone to increase the
microphone sensitivity.
Make sure that the pendant microphone is positioned with the black emitter facing
away from you and is free of obstructions.
Check the connection of the pendant microphone to the AP-60. The light on the
AP-60 should match the channel selected on the pendant microphone.
If you're using more than one microphone, make sure that each microphone is set
to use a different channel.
Check to see if the red light in the center of the IR dome sensor is lit. If it's not,
contact your maintenance department to check the cable connections.
Use the Gain control wheel on the pendant microphone to increase the
microphone sensitivity.
Adjust the audio levels, see page 16 for details.
Adjust the Gain control wheel on the pendant microphone to increase the
microphone sensitivity.
Adjust the audio levels, see page 16 for details.
Solution
Make sure you're within about 20 feet of the AP-60. Point the remote control toward
the AP-60.
You may need to replace the remote control's batteries (see page 18).
Turn off nearby equipment that emits infrared energy, such as a radiant room
heater.
Contact Epson for help.
21