Siemens WT45N202GB 사용자 설명서 및 설치 지침 - 페이지 38
{카테고리_이름} Siemens WT45N202GB에 대한 사용자 설명서 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens WT45N202GB 44 페이지. Tumble dryer
Siemens WT45N202GB에 대해서도 마찬가지입니다: 설치 및 운영 지침 매뉴얼 (36 페이지), 설치 및 운영 지침 매뉴얼 (40 페이지)
페이지 인쇄
en Troubleshooting
Fault
The length of the pro-
gramme changes dur-
ing the drying cycle.
Pumping noise.
Buzzing noise.
The drying time is too
long.
Water is leaking from
the appliance.
The laundry is too
damp.
38
Cause and troubleshooting
The programme operation is optimised electronically.
This may change the programme duration.
Not a fault – no action required.
▶
Condensation pump active.
Not a fault – normal operating noise.
▶
Compressor ventilation active.
Not a fault – normal operating noise.
▶
Fluff filter is soiled.
→ "Cleaning the fluff filter", Page 28
▶
The ambient temperature is greater than 30 °C.
Ensure that the ambient temperature is below 30
▶
°C.
The ambient temperature is lower than 15 °C.
Ensure that the ambient temperature is above 15
▶
°C.
Insufficient air circulation at the appliance's installation
location.
Ventilate the appliance's installation location.
▶
The appliance's ventilation opening is blocked.
Ensure that the ventilation opening of the appliance
▶
is kept clear.
Heat exchanger is soiled.
Opening the base unit.
1.
→ "Opening the base unit", Page 32.
Cleaning the heat exchanger.
2.
→ "Cleaning the base unit", Page 33.
Closing the base unit.
3.
→ "Closing the base unit", Page 34.
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 16
▶
Water drain hose is not connected correctly.
Ensure that the water drain hose is connected cor-
▶
rectly.
→ "Connecting the water drain hose", Page 14
Unsuitable programme for the type of fabric.
Set a timed programme for the subsequent drying.
▶
→ "Programmes", Page 24
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.