Siemens XQG62-WS10K1R81W 사용 설명서 및 설치 지침 - 페이지 33

{카테고리_이름} Siemens XQG62-WS10K1R81W에 대한 사용 설명서 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens XQG62-WS10K1R81W 34 페이지.
Siemens XQG62-WS10K1R81W에 대해서도 마찬가지입니다: 사용 설명서 및 설치 지침 (40 페이지)

페이지 인쇄
Siemens XQG62-WS10K1R81W 사용 설명서 및 설치 지침
Before washing for the first
time
The washing machine was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Drum clean programme the first time
without washing.
The washing machine must have
Note:
been installed and connected properly.
See chapter Installing ~ Page 28
Insert mains plug.
1.
Turn the tap on.
2.
Close the washing machine door.
3.
Do not load any washing.
Select Drum clean 40°C
4.
programme.
Open the detergent drawer.
5.
Pour approx. 1 litre of water into
6.
dispenser II.
Add standard detergent to
7.
dispenser II according
to manufacturer's instructions for
light soiling.
To prevent frothing, use only
Note:
half the recommended amount
of detergent. Do not use any
standard or mild detergents.
Close the detergent drawer.
8.
Select Start/Reload.
9.
When the programme ends, switch
10.
off the appliance.
Your washing machine is now ready
for use.
Installation and connection

Transportation

Remove covers and keep in a safe
1.
place.
If required, use a screwdriver.
Insert all 4 sleeves.
2.
Clamp mains cable on the holders.
Insert and tighten the bolts.
Before switching on the appliance:
Notes
Always remove the transportation
■
protection devices!
To prevent unused detergent from
■
flowing into the outlet during the next
wash: Pour 1 litre of water into
dispenser II and start the Spin
programme.
en
33