Cisco 7925G-EX 설치 매뉴얼 - 페이지 13

{카테고리_이름} Cisco 7925G-EX에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7925G-EX 21 페이지. Wavelink avalanche management console
Cisco 7925G-EX에 대해서도 마찬가지입니다: 데이터시트 (8 페이지), 릴리스 정보 (16 페이지), 액세서리 매뉴얼 (20 페이지), 관리 매뉴얼 (19 페이지), 사용자 설명서 (10 페이지), 사용자 설명서 (16 페이지), 관리 매뉴얼 (23 페이지), 설치 매뉴얼 (12 페이지), 관리 매뉴얼 (14 페이지)

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Setup

Charge Phone Battery Using USB Cable and PC

The following figure shows how to connect your phone to a PC to charge the phone battery.

Figure 5: Charge the phone battery using the USB cable and PC

Procedure

Step 1

Insert the phone connector on the USB cable into the phone.

Step 2

Insert the USB A-type connector into the USB port on your PC.

Step 3

Monitor the indicator light after the phone briefly displays USB Connected on the status line.

Step 4

If you see the Found New Hardware Wizard popup message, stop the wizard from opening when

connecting to USB port, using the following steps:

a) Click Next to use the wizard dialog box.

b) In the Update New Software dialog, click No, not this time, and click Next.

c) Click Install the Software automatically (Recommended) and click Next.

d) After a few moments, the Cannot Install This Hardware dialog displays. Click Don't prompt me again

to install this software.

e) Click Finish to close the dialog box.

Note