Cisco 7926G 설치 매뉴얼 - 페이지 4

{카테고리_이름} Cisco 7926G에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7926G 21 페이지. Wavelink avalanche management console
Cisco 7926G에 대해서도 마찬가지입니다: 릴리스 정보 (16 페이지), 액세서리 매뉴얼 (20 페이지), 관리 매뉴얼 (19 페이지), 사용자 설명서 (10 페이지), 사용자 설명서 (16 페이지), 관리 매뉴얼 (23 페이지), 설치 매뉴얼 (12 페이지), 관리 매뉴얼 (14 페이지)

BAT is included in Cisco Unified Communications Manager 5.0 or later, but it is a plug-in for earlier

Note

releases.

For detailed instructions about using BAT, see the following documents:

• For Cisco Unified Communications Manager Release 5.0 and earlier, see Bulk Administration Tool User

• For Cisco Unified Communications Manager Release 6.0 and later, see Cisco Unified Communications

When using BAT to add a Cisco Unified Wireless IP Phone, use the default setting for the phone load.

Note

The phone load name includes symbols (-, _, .) and BAT does not permit symbols in an entry.

Cisco Unified Communications Manager Administration Phone Addition

Add phones individually by using Cisco Unified Communications Manager Administration. To do so, obtain

the MAC address for each phone before you begin. See

Addition Methods, on page 2

Perform one of the following after collecting the MAC addresses:

• Cisco Unified Communications Manager Release 5.0 or later: Choose Device > Phone and click Add

• Cisco Unified Communications Manager Release 4.x: Choose Device > Add a New Device.

For additional instructions and conceptual information about Cisco Unified Communications Manager, see

the Cisco Unified Communications Manager Administration Guide and Cisco Unified Communications

Manager System Guide.

Device Support

Cisco Unified Communications Manager Release 4.3 and later require a device package or service release

update installed to enable device support for the Cisco Unified Wireless IP Phone. Device packages including

support for the Cisco Unified Wireless IP Phone are available at

sw-voice.shtml.

Review the following warnings before installing the Cisco Unified Wireless IP Phone. To see translations of

these warnings, see the Regulatory Compliance and Safety Information for the Cisco Unified Wireless IP

Phone 7920 Series and Peripherals document that accompanied the device.

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide

Guide for Cisco Unified Communications Manager.

Manager Bulk Administration Guide.

for instructions.

New.

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Setup

Cisco Unified Communications Manager Phone

http://www.cisco.com/kobayashi/sw-center/