Cisco 7936 - IP Conference Station VoIP Phone 시스템 매뉴얼 - 페이지 31
{카테고리_이름} Cisco 7936 - IP Conference Station VoIP Phone에 대한 시스템 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7936 - IP Conference Station VoIP Phone 50 페이지. Ip phone conference station
Cisco 7936 - IP Conference Station VoIP Phone에 대해서도 마찬가지입니다: 시스템 매뉴얼 (36 페이지), 전화 매뉴얼 (49 페이지), 빠른 시작 매뉴얼 (6 페이지), 빠른 참조 매뉴얼 (2 페이지)
페이지 인쇄
Chapter 40
Cisco IP Phones
Note
Making and Receiving Multiple Calls Per Directory Number
Note
Transfer and Conference Behavior
OL-7135-01
This check box only applies to the actual directory number and partition. It does
not apply to the other device settings such as voice-messaging profile, call
forwarding options, or MLPP. If any of these settings are changed for a shared
line, then all devices get changed.
For directory number configuration and update information, see
Directory Numbers"
in the Cisco CallManager Administration Guide. For
information about deleting and updating unassigned directory numbers, see
"Deleting Unassigned Directory Numbers"
Numbers"
in the Cisco CallManager Administration Guide.
Cisco CallManager supports various behaviors when users make and receive
multiple calls per DN: Transfer/Direct Transfer and Conference/Join.
Transfer allows different line appearances in one device to initiate independent
transfer transactions and allows multiple transfer transactions per line appearance
per device.
Conference allows different line appearances in one device to initiate independent
conference transactions and allows multiple conference transactions per line
appearance per device.
Devices that do not support multicall display, such as Cisco IP Phone Model
7910, cannot transfer or conference two existing calls together.
If only one active call exists on the directory number, the first invocation of a
feature results in putting the active call on hold and initiating a new call by using
the same directory number. When the new call gets set up, the second invocation
of the same feature starts the feature operation. The first invocation of
Transfer/Conference will always initiate a new call by using the same directory
number, after putting the active call on hold.
Directory Numbers
and
"Updating Unassigned Directory
Cisco CallManager System Guide
"Configuring
40-31