Samsung U32J590UQ Series 사용자 설명서 - 페이지 37
{카테고리_이름} Samsung U32J590UQ Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Samsung U32J590UQ Series 48 페이지.
Samsung U32J590UQ Series에 대해서도 마찬가지입니다: 사용자 설명서 (48 페이지), 사용자 설명서 (48 페이지), 사용자 설명서 (50 페이지), 사용자 설명서 (48 페이지)
페이지 인쇄
PC/AV Mode
Set
PC/AV Mode
to AV. The picture size will be enlarged.
This option is useful when you view a movie.
•
Set to
PC
when connected to a PC.
•
Set to
AV
when connected to an AV device.
― Supplied for the wide models only such as 16:9 or 16:10.
― If the monitor (when set to HDMI1, HDMI2, DisplayPort) is in power saving mode or is displaying the
message
Check Signal
Cable, press the
or AV.
DisplayPort Ver.
Select your Displayport.
― Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
― If the monitor (when set to HDMI1, HDMI2, DisplayPort) is in power saving mode or is displaying the
message
Check Signal
Cable, press the
or 1.2↑.
― If you select 1.1, the maximum resolution of your screen drops to 2560 x 1440 due to the limitations in HBR1
transmission speeds.
Source Detection
Select either
Auto
or
Manual
as the method to recognize input signal.
― Not available when
PIP/PBP Mode
is set to On.
icon to display the On Screen Display (OSD). You can select
icon to display the On Screen Display (OSD). You can select
Key Repeat Time
Control the response rate of a button when the button is pressed.
Acceleration,
1
sec, or
2 sec
can be selected. If
when a button is pressed.
Power LED On
PC
Configure the settings to enable or disable the power LED located at the lower part of the product.
•
Working: The power LED is on when the product is turned on.
•
Stand-by: The power LED is on when the product is turned off.
Reset All
Return all the settings for the product to the default factory settings.
1.1
No Repeat
is selected, a command responds only once
37