Epson BrightLink 1480Fi 사용자 설명서 부록 - 페이지 14

{카테고리_이름} Epson BrightLink 1480Fi에 대한 사용자 설명서 부록을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson BrightLink 1480Fi 34 페이지.
Epson BrightLink 1480Fi에 대해서도 마찬가지입니다: 여기에서 시작하기 매뉴얼 (6 페이지)

페이지 인쇄

Details of Updated Projector Menus (Version 1.50)

• Do not copy any other files or folders to the removable disk.

Otherwise, the files or folders may be lost.

• The projector turns off automatically if the USB cable or the

power cord are disconnected before the firmware file can be

copied to the removable disk. Perform the procedure again.

Perform the steps to safely remove a USB device from the computer

and disconnect the USB cable from the projector.

All of the projector's indicators start flashing and the firmware update

starts. After the update finishes normally, the projector enters standby

mode (only the power indicator is lit blue). If Direct Power On is set to

On in the projector's Operation menu, the projector turns back on

again.

After finishing the update, check the Information menu from the projector's

Management menu to make sure Version is updated to the desired firmware

version.

• When all indicators flash rapidly, the firmware update may have

failed. Disconnect the power cord from the projector and then

reconnect it to the projector. If the indicators continue to flash even

after reconnecting the power cord, remove the power plug from the

electrical outlet and contact Epson.

• If no operations are performed for 20 minutes in update mode, the

projector turns off automatically. Perform the procedure again.