Siemens SIMATIC S7-1200 안전 프로그래밍 매뉴얼 - 페이지 31

{카테고리_이름} Siemens SIMATIC S7-1200에 대한 안전 프로그래밍 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC S7-1200 48 페이지. Controlling several fans (ebm-papst) via modbus rtu
Siemens SIMATIC S7-1200에 대해서도 마찬가지입니다: 매뉴얼 (30 페이지), 사용 설명서 (36 페이지), 매뉴얼 (40 페이지), 매뉴얼 (17 페이지), 매뉴얼 (31 페이지), 매뉴얼 (49 페이지), 매뉴얼 (20 페이지)

페이지 인쇄

3 Methods for Safety Programming

3.9.4

Transferring HMI signals to the safety program

Human-machine interfaces (HMIs) are convenient, essential components in a

machine operator's daily work. In order to use this convenience for operator control

and monitoring of processes and plants even in safety-related applications,

additional measures are required.

Writing tags from the HMI to the safety program is a problem for the following

reasons:



Signals from the HMI panel are not safety-related and not monitored. An error

can result in forbidden changes of safety-related values, which increases the

risk.



Communication between the HMI and the CPU is acyclic. As a result, the

HMI's write access may take place while processing the safety program.

The first program run then still uses the original value. The encoded user

program uses the value that has been updated in the meantime. This causes

data corruption in the safety program and therefore a stop of the CPU (see

Chapter 5).

Recommendation

Use another data block for communication with the HMI and copy the safety-

related data in the standard user program to the data buffer.

Figure 3-12: Data exchange between HMI and safety program

Safety Programming Guideline

Entry ID: 109750255,

V1.0,

10/2017