Siemens SIMATIC S7-1200 매뉴얼 - 페이지 19

{카테고리_이름} Siemens SIMATIC S7-1200에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC S7-1200 40 페이지. Controlling several fans (ebm-papst) via modbus rtu
Siemens SIMATIC S7-1200에 대해서도 마찬가지입니다: 매뉴얼 (30 페이지), 사용 설명서 (36 페이지), 안전 프로그래밍 매뉴얼 (48 페이지), 매뉴얼 (17 페이지), 매뉴얼 (31 페이지), 매뉴얼 (49 페이지), 매뉴얼 (20 페이지)

페이지 인쇄

4 Configuration and Project Engineering

3.2 Blocks

Configuration and Project Engineering

This chapter describes the configuration steps necessary for you to create the

sample project. You will find helpful project engineering support, in particular if your

required configuration differs from the supplied application example in terms of

hardware and component parameterization.

Requirement



Configuration software

The software components are installed on your development system according

to Table 2-3.



SINAMICS V20

The parameterization is performed using the built-in BOP (Basic Operator

Panel). Therefore, on the line side, the drive has already been supplied with

230 or 400V – depending on the version.



SIMATIC S7-1200/1500

In TIA Portal, you have opened a new software project or a project to be

expanded/modified.

Default values

The below parameterization of the SINAMICS V20 assumes that the device is in

the as-supplied state or has been reset to factory default. In this state, there is a

default parameterization that forms the basis for Table 4-1. Parameters that do not

have to be changed for this application example regarding the default values will

not be mentioned in the following sections.

When you add a device, for example a controller, from the hardware catalog to the

project in TIA Portal, an associated default parameterization will be created. This

default parameterization will be used as a basis in Table 4-2. Parameters and

settings that do not have to be changed for this application example regarding the

default values will not be mentioned in the following sections.

Note

Both the procedure for parameterizing the SINAMICS V20 and the one for

configuring the SIMATIC controllers in TIA Portal offer various options. The

following configuration steps represent one possible solution. Steps or

procedures deviating from this approach can also lead to the same goal.

SINAMICS V20 at S7-1200/1500 via USS

Entry ID: 109480894,

V1.0,

09/2018