Siemens SIMATIC S7-1200 매뉴얼 - 페이지 24

{카테고리_이름} Siemens SIMATIC S7-1200에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC S7-1200 49 페이지. Controlling several fans (ebm-papst) via modbus rtu
Siemens SIMATIC S7-1200에 대해서도 마찬가지입니다: 매뉴얼 (30 페이지), 사용 설명서 (36 페이지), 안전 프로그래밍 매뉴얼 (48 페이지), 매뉴얼 (40 페이지), 매뉴얼 (17 페이지), 매뉴얼 (31 페이지), 매뉴얼 (20 페이지)

페이지 인쇄

3 Mode of Operation

Sequential call of FC "ReadWrite"

3.5.2

To execute several register accesses successively, the parameters have to be

handed to the FC "ReadWrite" in the form of a sequencer.

In the OB "Main" this is presented in networks 4 through 7.

Task

The following actions are to be performed successively:

1. Reading input register 16#D015 of fan 1

2. Reading holding registers 16#D108 through 16#D10D of fan 2 (see chapter

3.5.1)

3. Writing the value 1 to holding register 16#D105 of fan 1 ("internal parameter

set") (corresponds to: parameter set 2)

Figure 3-8

The sequencer is started in network 4. The step is displayed in white font. The jobs

are processed in the networks 5 through 7. A job consists of the parameter

handover and the subsequent action in case of the ready message ("done").

Subsequently, the program continues with the next step.

The steps are called in the reverse order of the networks.

This is necessary to prevent "sliding through" the steps.

You can check the function of the sequencer using the watch table "ReadWrite":

Figure 3-7

Successful writing to holding register 16#D105 is accomplished by reading the

Controlling several fans (ebm-papst) via Modbus RTU

Entry ID: 109476801,

V2.0,

shows the program sequence.

Cyclically retrieved values (input

Figure 3-7

09/2018

registers):

in line 38.