Samsung VRR P10 제품 설명서 - 페이지 13

{카테고리_이름} Samsung VRR P10에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Samsung VRR P10 50 페이지.

6.1.4 Cabinet Power Cable Connection：

1. Install the power distribution cabinet and install it near the screen according to the

site conditions to avoid the main power cable being too long.

2. Install the cabinet, refer to Chapter 6.

3. After the cabinet is installed, connect the power cord according to the design

drawings.

Figure 6-1 shows the connection of the power cable of the VRR P10 display.

①power distribution cabinet

②main power cord

③power cascade

6.2 Signal Cable Connection

6.2.1 Sender Box

The sending box contains a sending card to send video data to the display.

6.2.2 Main Signal Cable

Send the main signal line between the box and the display screen to transmit video

data with a length of less than 70m.

Remarks: When the transmission distance is greater than 70m, it is possible to

transmit data by optical fiber, and the longest distance is 20 kilometers.

Signal cascading line: used for signal transmission between cabinets.

6.2.3 Cabinet Signal Cable Connection:

1. During the installation process, pay attention to the protection of the cabinet to

Install the send box, arrange the main signal, and put it next to the display installation

position.

2. Install the cabinet, refer to Chapter 6.

3. After the cabinet is installed, connect the signal wires according to the design

drawings.

Figure 6-2 shows the connection of signal lines in the arrangement of VRR P10 1*46.

Each main network cable carries 128*96*46=565,248 pixels. In the figure:

① indicates the sending box

13 / 50