Cisco 7941G - Unified IP Phone VoIP 관리 매뉴얼 - 페이지 4

{카테고리_이름} Cisco 7941G - Unified IP Phone VoIP에 대한 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7941G - Unified IP Phone VoIP 16 페이지. Unified communications manager 9.0 (sccp and sip)
Cisco 7941G - Unified IP Phone VoIP에 대해서도 마찬가지입니다: 사용자 설명서 (21 페이지), 사용자 설명서 (25 페이지), 데이터시트 (7 페이지), 빠른 참조 (2 페이지), 사용자 설명서 (4 페이지), 사용자 설명서 (4 페이지), 사용자 설명서 (13 페이지), 관리 매뉴얼 (12 페이지), 사용자 설명서 (13 페이지), 전화 매뉴얼 (30 페이지), 사용자 설명서 (13 페이지), 사용자 설명서 (6 페이지), 문제 해결 및 유지 관리 (27 페이지)

Speakerphone

By default, the wideband-capable speakerphone is enabled on the Cisco Unified IP Phone.

Disable Speakerphone

To disable the speakerphone using Cisco Unified CM Administration, perform the following procedure:

Procedure

Step 1

Choose Device > Phone and locate the phone you want to modify.

Step 2

In the Phone Configuration window, check Disable Speakerphone.

Step 3

Click Apply.

Headset

Although Cisco Systems performs internal testing of third-party headsets for use with the Cisco Unified IP

Phones, Cisco does not certify or support products from headset or handset vendors.

We recommend that the use of good quality external devices, for example, headsets that are screened against

unwanted radio frequency (RF) and audio frequency (AF) signals. Depending on the quality of headsets and

their proximity to other devices such as cell phones and two-way radios, some audio noise or echo may still

occur. An audible hum or buzz may be heard by either the remote party or by both the remote party and the

Cisco Unified IP Phone user. Humming or buzzing sounds can be caused by a range of outside sources; for

example, electric lights, electric motors, or large PC monitors. See

information.

In some cases, hum can be reduced or eliminated by using a local power cube or power injector.

Note

These environmental and hardware inconsistencies in the locations where Cisco Unified IP Phones are deployed

means that there is not a single headset solution that is optimal for all environments.

We recommend that customers test headsets in their intended environment to determine performance before

making a purchasing decision and deploying en masse.

Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco

Unified Communications Manager 9.0 (SCCP and SIP)

Cisco Unified IP Phones Installation

External Device Use, on page 6

for more