Siemens SITRANS LVL200E 사용 설명서 - 페이지 21
{카테고리_이름} Siemens SITRANS LVL200E에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SITRANS LVL200E 40 페이지. Vibrating switches
Siemens SITRANS LVL200E에 대해서도 마찬가지입니다: 사용 설명서 (40 페이지), 사용 설명서 (44 페이지), 사용 설명서 (16 페이지)
페이지 인쇄
Function/Configuration
Signal lamp (1)
*7ML19985KY01*
6
Setup
6.1
General information
The figures in brackets refer to the following illustrations.
In the basic setting, products with a density ≥ 0.7 g/cm³ (0.025 lbs/in³)
can be detected. For products with lower density, you have to set the
switch to ≥ 0.5 g/cm³ (0.018 lbs/in³).
On the electronics module you will find the following display and
adjustment elements:
•
Control lamp for indication of the switching condition (1)
•
DIL switch for characteristics reversal - min./max. (2)
•
DIL switch for sensitivity adjustment (3)
•
Simulation key (4)
Note:
Always immerse the tuning fork of SITRANS LVL200E in a liquid to
test its function. Do not test the function of SITRANS LVL200E with
your hand. This can damage the sensor.
6.2
Adjustment elements
Fig. 12: Oscillator SWE60N - NAMUR output
1
Control lamp (LED)
2
DIL switch for characteristics reversal
3
DIL switch for sensitivity adjustment
4
Simulation key
5 EMC filter element
Single-coloured control lamp for indication of the switching condition.
•
red = High current ≥ 2.6 mA
•
dark = Low current ≤ 0.6 mA
•
red (flashing) = Failure ≤ 0.6 mA
SITRANS LVL200E - Operating Instructions
1
2
3
4
5
21