Siemens SITRANS RD500 사용 설명서 - 페이지 6

{카테고리_이름} Siemens SITRANS RD500에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SITRANS RD500 8 페이지. Configuring sitrans rd500 for connection to multiranger with modbus rtu
Siemens SITRANS RD500에 대해서도 마찬가지입니다: 사용 설명서 (48 페이지), 사용 설명서 (8 페이지), 사용 설명서 (8 페이지), 애플리케이션 매뉴얼 (6 페이지), 매뉴얼 (11 페이지), 적용 사례 (9 페이지)

페이지 인쇄

WIRING

WIRING CONNECTIONS

All conductors should meet voltage and current ratings for each terminal. Also,

cabling should conform to appropriate standards of good installation, local codes

and regulations. When wiring the module, use the numbers on the label to identify

the position number with the proper function. Strip the wire, leaving approximately

1/4" (6 mm) of bare wire exposed. Insert the wire into the terminal, and tighten.

INPUT CONNECTIONS

17 18

Sinking Input

LEDS

STS – STATUS LED

The Status LED is a dual color LED that provides information regarding the

state of the module. This includes indication of the various stages of the start-up

routine (power-up), as well as any errors that may occur.

Startup Routine

Rapidly Flashing Red

Module is currently being flash upgraded. This

occurs for four seconds during a power up.

Steady Red

Module switching to configuration.

Green

Module performing normally.

Error States

Solid Red

Module not controlling, and not communicating.

Green/Pulsing Red

Module is controlling properly, but has lost

communication with the RD500.

7ML19985MD01

OUTPUT CONNECTIONS

13 14 15 16 17 18

11 12

Power

Sourcing Input

Relay Version

ALM – ALARM LED

The Alarm LED indicates the presence of a fault condition.

FIRMWARE UPGRADE

The module's firmware is stored in flash memory so that software/hardware

conflicts are avoided, and so that software features may be added in the future.

During a download, RD500 software compares its own library of firmware files

with those stored in the RD500 module. If they do not match, RD500 software will

download the necessary files. The RD500 then checks to make sure that the I/O

modules contain the same firmware. If they contain a different revision, the RD500

will automatically copy those files into the module's flash memory. During this

process, the module LEDs will flash rapidly, starting with the top row, and

progressing through the remaining rows until the process is complete.

SITRANS RD500

Terminals 13 to 18

Terminals 7 to 12

Terminals 1 to 6

Load

Page 4