Siemens Sitrans WM100 사용 설명서 - 페이지 11

{카테고리_이름} Siemens Sitrans WM100에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens Sitrans WM100 22 페이지. Motion sensing switch
Siemens Sitrans WM100에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지)

페이지 인쇄

5.2

WM100 Typical Wiring

Should the time delay feature on start up not be required, power should be applied

continuously from a separate source. Typically this would be desirable for automatic

upstream start up of conveying devices after down stream drive has reached its operation

speed.

Note

1. Interlocks and safety pull switches are not shown.

2. If 'START' is initiated by programmable logic controller, closure time may be of insufficient

duration to allow WM100 contact to latch. In such a case, program a timer contact into

circuit.

3. CSA requires a 3 A or less fuse to protect contacts. For 240 V AC, protect contacts with a

1500 VA transformer as well.

SITRANS WM100

Operating Instructions, 07/2017, A5E45103494-AA

Connecting

5.2 WM100 Typical Wiring