Siemens DVF5311 설치 및 운영 지침
{카테고리_이름} Siemens DVF5311에 대한 설치 및 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens DVF5311 2 페이지.
페이지 인쇄
Short and handy: everything
en
your dishwasher needs...
Before using for the first
time, read the Installation
and Operating Instruc-
tions!
Add salt.
Add rinse-aid.
Add detergent.
Select programme.
Switch appliance ON
Press main switch, choose programme.
Close door.
Switch appliance OFF
Signal sounds, open door. End-of-programme
indicator flashes, press main switch.
Setting the water softening system *
Find out the water
hardness at your water
utility company and
enter below
* only before using the
dishwasher for the first
time or if the water hard-
ness changes
Dissolves limescale (not required for set value 0!)
Everything is sparkling clean ...
Very dirty dishes, a lot of detergent ...
Quick, economical or intensive ...
Overview of programmes
This overview indicates the max. possible number of
programmes. The programmes which correspond to your
appliance can be found on your appliance fascia.
The programme data are values measured in the
laboratory in compliance with Standard EN 50242.
Deviations is practice are possible.
Additional programmes **
, off we go...
, everything OK...
** on some models
Read off the setting
dH
fH
Clarke mmol/l
Setting
0–6
0–11
0–8
0–1,1
0
7–16
12–29
9–20
1,2–2,9
1
17–21
30–37
21–26
3,0–3,7
2
22–35
38–60
27–44
3,8–6,2
3
Only before using
Unscrew
the dishwasher
the lid.
for the first time
pour approx. 1 l /
2 pt water into the
salt opening.
Press mark 1,
lift up lid 2.
Warning,
If required, open
the lid (press the
combination
pin).
products are not
suitable for all
programmes,
follow manufac-
turer's instructions.
Duration in minutes
Power consumption in kWh
Water consumption in litres
Increased flexibility ...
Quickly sorted
and then select a setting
– Hold down programme button B and switch on the main
A
B
C
switch, then release the buttons. The
buttons A and B illuminate (water hardness setting was set
Reset
to 2 at the factory).
– Each time button B is depressed, the setting increases by
one (0-3). If buttons A, B and C illuminate, the maximum
water hardness setting has been reached. If the water
hardness setting is now increased again, the lights go out
and the water hardness setting is set to 0.
– Switch off the main switch. The selected setting has been
stored in the appliance.
Pour in max.
1.5 kg / 3 lb 5 oz
salt (never deter-
gent!)
Refill whenever level indicator is light!
Pour in
rinse aid.
Pour in
detergent.
Intensive
Normal
70
65
105
102
1,50
1,30
20
20
Upper basket cleaning
...Only the crockery in the
upper basket is cleaned
. display flashes and
Screw on the
lid. Switch on
dishwasher
immediately.
Close the
lid. CLICK!
Push the lid
shut, press.
PLOP!
Eco
Quick
Prerinse
50
35
140
29
13
0,95
0,60
0,12
12
12
5