Siemens IQ300 SN23EC14CG 빠른 참조 매뉴얼
{카테고리_이름} Siemens IQ300 SN23EC14CG에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens IQ300 SN23EC14CG 2 페이지.
Siemens IQ300 SN23EC14CG에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (2 페이지)
페이지 인쇄
en
Before using for the first time, read the operating instructions.
Setting up Home Connect
Tip: Connect your appliance to a mobile device. You can con-
veniently change all settings via the Home Connect app.
Install the Home Connect app on your mo-
1.
bile device and follow the instructions.
Scan the QR code using the Home Con-
2.
nect app.
How to use your appliance
Load the tableware.
1.
Only clean tableware that is suitable for dish-
washers. Remove large remnants of food from
the tableware. Check that the spray arms can ro-
Overview of water hardness settings
You can find an overview of the
water hardness values that can
be selected here.
A table of country-specific units
can be found in the instruction
manual.
Hardness
mmol/l
Setting
range
value
Soft
0 - 1.1
H00
Soft
1.2 - 1.4
H01
Adding special salt
To avoid damage to the appliance, only add special
salt to the dispenser for special salt just before the
programme starts.
Unscrew the lid of the dispenser for special salt
1.
and remove.
On initial start-up: Fill the dispenser right up with
2.
water.
Adding rinse aid
Press the catch on the lid
1.
of the dispenser for rinse
aid
and lift
.
Adding detergent
Add the detergent to the
1.
dry detergent dispenser.
tate freely.
Add detergent.
2.
Switch on the appliance
.
3.
Setting the water softening sys-
tem
Medium
1.5 - 1.8
H02
Press
Medium
1.9 - 2.1
H03
1.
To open the basic settings, press
Medium
2.2 - 2.9
H04
2.
Hard
3.0 - 3.7
H05
a The display shows Hxx.
Hard
3.8 - 5.4
H06
a The display shows
Hard
5.5 - 8.9
H07
Press
3.
water hardness has been set.
To save the settings, press
4.
Add the special salt to the
3.
dispenser. The water in the
dispenser is displaced and
forced out. Never add de-
tergent.
Place the lid back on the dispenser and turn to
4.
close.
Add rinse aid up to the
2.
max mark.
2
1
Close the lid of the dispenser for rinse aid.
3.
a The lid clicks into position.
Close the lid of the deter-
2.
50 ml
gent dispenser.
25 ml
15 ml
a The lid clicks into position.
Select the programme.
4.
Start the programme
.
5.
Remove the tableware at the end of the pro-
6.
gramme.
Programmes
The programme data has been meas-
ured in the laboratory according to
.
European standard EN 60436.
The consumption figures depend on
for 3 seconds.
the programme and additional func-
tion selected.
.
The running time will change if the
repeatedly until the right
rinse aid system is switched off or
rinse aid needs to be added.
for 3 seconds.
Programme
Intensive 70°
Auto 45-65°
Eco 50°
Speed 65°
Speed 45°
Machine Care
Favourite
1
half standard load
max
To cancel the programme, press
7.
approx. 4 seconds.
The programme is cancelled and ends after ap-
prox. 1 minute.
1) Duration [h:min]
2) Energy [kWh]
3) Water [l]
1) 2:05 - 2:15
2) 1,300 - 1,400
3) 11,5 - 14,0
1) 1:40 - 2:45
2) 0,900 - 1,500
3) 7,0 - 15,5
1) 4:35
2) 0,736
3) 9,5
1) 1:00
2) 1,300
3) 10,5
1
1) 0:29
2) 0,800
3) 10,5
1) 2:10
2) 1,350
3) 15,2
1) 0:15 - 0:15
2) 0,050 - 0,050
3) 4,0 - 4,0
for