Siemens SMI50E56EU 사용 설명서 - 페이지 11
{카테고리_이름} Siemens SMI50E56EU에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SMI50E56EU 40 페이지.
페이지 인쇄Rinse aid
R i n s e
As soon as the rinse-aid refill
indicator ` is lit on the fascia, there
is still a rinse-aid reserve of 1-2 rinsing
processes. Refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only
rinse aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH,
26° Clarke, 3.7 mmol/l) only. If
the water hardness is over 21° dH,
rinse aid must be used.
1. Open the dispenser 1j by pressing
and lifting the plate on the cover.
2. Carefully pour rinse aid up
to the max. mark in the filler opening.
a i d
3. Close cover until it clicks shut.
4. To prevent excessive foam formation
during the next rinse cycle, remove
any rinse aid which has run over with
a cloth.
Setting amount of rinse aid
The amount of rinse aid can be set from
:
to :
. Please set rinse aid on
:
to obtain very good drying results
( :
is already set in factory).
Change this setting, only if streaks
(select lower setting) or water stains
(select higher setting) are left on the
utensils.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press and hold down the START
button @.
4. Rotate programme selector 8
until : ... s indicated on the digital
display H.
5. Release button.
The factory set value :
the digital display H.
To change the setting:
1. Rotate programme selector 8 until
the required value is indicated on the
digital display H.
2. Press START button @.
The set value is saved.
Switching off rinse aid refill
indicator
If the rinse-aid refill indicator ` is
impaired (e.g. when using combined
detergents containing rinse aid
component), it can be switched off.
Proceed as described under "Setting
amount of rinse aid" and set the
value to :
The rinse aid refill indicator ` is now
switched off.
Rinse aid
is lit on
.
en
11