Siemens SN Series 사용 설명서 - 페이지 35

{카테고리_이름} Siemens SN Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SN Series 38 페이지. Dishwasher
Siemens SN Series에 대해서도 마찬가지입니다: 작동 지침 (38 페이지), 사용 설명서 (42 페이지), 사용 설명서 (42 페이지), 사용 설명서 (44 페이지), 사용 설명서 (46 페이지), 사용 설명서 (44 페이지), 사용 설명서 (42 페이지), 사용 설명서 (48 페이지), 사용 설명서 (40 페이지), 사용 설명서 (42 페이지), 사용 설명서 (44 페이지), 사용 설명서 (40 페이지)

페이지 인쇄

Water pressure:

at least 0.05 MPa (0.5 bar), maximum

1 MPa (10 bar). At a higher water

pressure: connect pressure-reducing

valve ahead.

Inlet rate:

minimum 10 litres/minute

Water temperature:

Note printing on the water inlet hose!

If models are marked with 25°,

the water temperature may be max.

25 °C (cold water).

For all other models:

cold water preferred; hot water max.

temperature 60 °C.

Installation and connection

Warm water connection

* depending on model

The dishwasher can be connected

to cold or hot water up to max. 60 °C.

Connection to hot water

is recommended if the hot water can be

supplied by energetically favourable

means and from a suitable installation,

e. g. solar heating system with

circulation line.

This will save energy and time.

The hot water setting :

to adjust your appliance optimally

to operation with hot water.

It is recommended to have a water

temperature (temperature of the

incoming water) of at least 40 °C

and no more than 60 °C.

It is not recommended to connect

the appliance to hot water if the water

is supplied from an electric boiler.

Setting hot water:

1. Close the door.

2. Switch on ON/OFF switch (.

3. Press and hold down the START

button @.

4. Rotate programme selector 8

until :

is indicated on the digital

display H.

5. Release button.

The factory-set value :

the digital display H.

To change the setting:

1. By rotating the programme

selector 8, you can switch the hot

water setting off :

2. Press START button @.

The set value is saved.

Wa r m wa t e r c o n n e c t i o n

allows you

is lit on

or on