Fill detergent dispenser with
detergent. Start the appliance without
utensils in the programme with
the highest rinsing temperature.
Clean the appliance with detergents/
appliance cleaners which
are particularly suitable for use with
dishwashers.
To ensure that the door seal always
remains clean and hygienic, regularly
clean it with a damp cloth and a little
washing-up liquid.
If the appliance is switched off for
a prolonged period, leave the door
ajar to prevent the formation of
an unpleasant odour.
Never use a steam cleaner to clean your
dishwasher. The manufacturer is not
liable for any consequential damage.
Regularly wipe the front of the appliance
and fascia with a damp cloth; water
and a little washing up liquid
are adequate. Do not use sponges with
a rough surface or abrasive detergents,
a rough surface or abrasive detergents,
a rough surface or abrasive detergents,
as these could scratch the surfaces.
Stainless steel appliances: To prevent
Stainless steel appliances: To prevent
Stainless steel appliances: To prevent
corrosion, avoid using sponge cloths
corrosion, avoid using sponge cloths
corrosion, avoid using sponge cloths
or wash them out thoroughly several
or wash them out thoroughly several
or wash them out thoroughly several
times before using for the first time.
times before using for the first time.
times before using for the first time.
ã
Warning – Health hazard
Warning – Health hazard
Warning – Health hazard
Never use other domestic detergents,
Never use other domestic detergents,
Never use other domestic detergents,
e.g. containing chlorine!
e.g. containing chlorine!
e.g. containing chlorine!
Special salt and rinse aid
Check the refill indicators @ and
H. If required, refill salt and/or
rinse aid.
Cleaning and maintenance
Filters
The filters 1Z keep large foreign
objects in the rinsing water away from
the pump. These foreign objects may
occasionally block the filters.
The filter system consists of a coarse
filter, a flat fine filter and a microfilter.
1. After each washing cycle check the
filters for residue.
2. Unscrew filter cylinder as illustrated
and take out filter system.
3. Remove any residue and clean filters
under running water.
4. Re-install filter system in reverse
sequence and ensure that the arrow
marks are opposite each other after
closing the filter system.
en
25
페이지 인쇄