Siemens SN Series 사용 설명서 - 페이지 31

{카테고리_이름} Siemens SN Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SN Series 44 페이지. Dishwasher
Siemens SN Series에 대해서도 마찬가지입니다: 작동 지침 (38 페이지), 사용 설명서 (38 페이지), 사용 설명서 (42 페이지), 사용 설명서 (42 페이지), 사용 설명서 (46 페이지), 사용 설명서 (44 페이지), 사용 설명서 (42 페이지), 사용 설명서 (48 페이지), 사용 설명서 (40 페이지), 사용 설명서 (42 페이지), 사용 설명서 (44 페이지), 사용 설명서 (40 페이지)

페이지 인쇄
Siemens SN Series 사용 설명서
Fault
Error code :
is lit.
Error code :
is lit.
A different error code is
indicated on the digital
display.
( :
to :
)
Display flashes.
Refill indicator for salt @
and/or rinse-aid H is lit.
Refill indicator for salt @
and/or rinse-aid H is not
lit.
Water is left in the
appliance at the end of the
programme.
Cause
Waste water pump blocked or
cover on the waste water pump is
not locked in position.
Mains voltage too low.
A technical fault has probably
occurred.
Door not closed properly.
No rinse aid.
No salt.
Sensor does not detect salt
tablets.
Refill indicator switched off.
There is still enough special salt/
rinse aid available.
Filter system or area under the
filters 1j is blocked.
Program has not ended yet.
Fault, what to do?
Remedial action
Clean pump and lock cover correctly. (See
"Waste water pump")
Not an appliance fault, have the mains
voltage and electrical installation checked.
Switch off appliances with the ON/OFF
switch (. After a short time restart the
appliance.
If the problem recurs, turn off the tap and
pull out the mains plug.
Call customer service and mention the error
code.
Close the door. Ensure that no objects
(utensil, fragrance dispenser) are protruding
over the basket and preventing the door
from closing.
Refill rinse aid.
Refill with special salt.
Use different special salt.
Activation/deactivation (see chapter Water
softening system/Special salt or Rinse aid).
Check refill indicator, levels.
Clean filters and area underneath (see
"Waste water pump").
Wait until programme ends or reset (see
"Terminating the programme").
en
31