Siemens SN26M231AU 사용 설명서 - 페이지 28
{카테고리_이름} Siemens SN26M231AU에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SN26M231AU 40 페이지.
페이지 인쇄aus
Fault, what to do?
Fault
Error code ":ƒˆ is lit.
A different error code is
indicated on the digital
display.
(":‹‚ to ":„‹)
Display flashes
Refill indicator for rinse-aid
` is lit.
Refill indicator for rinse-aid
` is not lit.
Water is left
in the appliance at the end
of the programme.
28
Cause
Mains voltage too low.
A technical fault has probably
occurred.
Door not closed properly.
No rinse aid.
Refill indicator switched off.
There is still enough rinse aid
available.
Filter system or area under
the filters 1J is blocked.
The programme has not yet
ended.
Remedial action
Not an appliance fault, have the mains
voltage and electrical installation checked.
Switch off appliances with the ON/OFF
switch (. After a short time restart
the appliance.
If the problem recurs, turn off the tap and
pull out the mains plug.
Call customer service and mention the error
code.
Close the door. Ensure that no objects
(utensil, fragrance dispenser) are protruding
over the basket and preventing the door
from closing.
Refill rinse aid.
Activation/deactivation (see chapter Rinse
aid).
Check refill indicator, level.
Clean filters and area underneath (see
Waste water pump).
Wait until programme ends or reset (see
Terminating the programme).