Siemens SP Series 사용 설명서 - 페이지 39

{카테고리_이름} Siemens SP Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SP Series 42 페이지.

페이지 인쇄

Electrical connection

Connect the appliance to an

■

alternating current only, ranging from

220 V to 240 V and 50 Hz or 60 Hz

via a correctly installed socket with

protective earth conductor. See

rating plate for required fusing 92.

The socket must be near

■

the appliance and freely accessible

following installation.

If the plug is not freely accessible, an

allpole disconnector with a contact

opening of at least 3 mm must be

fitted on the installation side

to satisfy the relevant safety

instructions.

The connection may be modified by

■

technicians only.

A power cord extension may be

■

purchased from customer service

only.

Use only a residual current operated

■

circuit-breaker which features

the symbol ‚. Only this extension

guarantees compliance with

the currently valid regulations.

The appliance features a water

■

damage protection system. Please

note the system will not function

unless the power supply

is connected.

Installation and connection

Removing the appliance

Also observe

the sequence of worksteps here.

1. Disconnect the appliance from

the power supply.

2. Turn off the water supply.

3. Undo the waste water and drinking

water connection.

4. Loosen fastening screws for

the furniture parts.

5. If fitted, remove the base panel.

6. Pull out the appliance, carefully

pulling the hose behind.