Siemens SX Series 사용 설명서 - 페이지 41

{카테고리_이름} Siemens SX Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SX Series 44 페이지. Dishwasher
Siemens SX Series에 대해서도 마찬가지입니다: 작동 지침 (38 페이지), 사용 설명서 (38 페이지), 사용 설명서 (42 페이지), 사용 설명서 (42 페이지), 사용 설명서 (46 페이지), 사용 설명서 (44 페이지), 사용 설명서 (42 페이지), 사용 설명서 (48 페이지), 사용 설명서 (40 페이지), 사용 설명서 (42 페이지), 사용 설명서 (44 페이지), 사용 설명서 (40 페이지)

페이지 인쇄

Setting hot water:

1. Open the door.

2. Switch on ON/OFF switch (.

3. Hold down programme button #

and press START button `

until : ... is indicated on the digital

display.

4. Release both buttons.

The LED for button # flashes and

the digital display h displays the

factory setting :

5. Press programme button # until

the factory set value :

is indicated on the digital

display h.

To change the setting:

1. By pressing the 3 button, you can

switch the hot water setting off :

or on :

2. Press START button `.

The set value is saved.

3. Close the door.

Installation and connection

Electrical connection

Connect the appliance to an

alternating current only, ranging from

220 V to 240 V and 50 Hz or 60 Hz

via a correctly installed socket with

protective earth conductor. See

rating plate for required fusing 9J.

The socket must be near

the appliance and freely accessible

following installation.

If the plug is not freely accessible, an

allpole disconnector with a contact

opening of at least 3 mm must be

fitted on the installation side

to satisfy the relevant safety

instructions.

The connection may be modified by

technicians only.

A power cord extension may be

purchased from customer service

only.

Use only a residual current operated

circuit-breaker which features

the symbol ‚. Only this extension

guarantees compliance with

the currently valid regulations.

The appliance features a water

damage protection system. Please

note the system will not function

unless the power supply

is connected.