Siemens SX Series 사용 설명서 - 페이지 11

{카테고리_이름} Siemens SX Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SX Series 40 페이지. Dishwasher
Siemens SX Series에 대해서도 마찬가지입니다: 작동 지침 (38 페이지), 사용 설명서 (38 페이지), 사용 설명서 (42 페이지), 사용 설명서 (42 페이지), 사용 설명서 (44 페이지), 사용 설명서 (46 페이지), 사용 설명서 (44 페이지), 사용 설명서 (42 페이지), 사용 설명서 (48 페이지), 사용 설명서 (40 페이지), 사용 설명서 (42 페이지), 사용 설명서 (44 페이지)

페이지 인쇄

Rinse aid

R i n s e

As soon as the rinse-aid refill

indicator ` is lit on the fascia, there

is still a rinse-aid reserve of 1-2 rinsing

processes. Refill with rinse aid.

The rinse aid is required for stain-free

utensils and clear glasses. Use only

rinse aid for domestic dishwashers.

Combined detergents with rinse-aid

component may be used up to a water

hardness of 21° dH (37° fH,

26° Clarke, 3.7 mmol/l) only. If

the water hardness is over 21° dH,

rinse aid must be used.

1. Open the dispenser 1j by pressing

and lifting the plate on the cover.

2. Carefully pour rinse aid up

to the max. mark in the filler opening.

a i d

3. Close cover until it clicks shut.

4. To prevent excessive foam formation

during the next rinse cycle, remove

any rinse aid which has run over with

a cloth.

Setting amount of rinse aid

The amount of rinse aid can be set from

to :

. Please set rinse aid on

to obtain very good drying results

( :

is already set in factory).

Change this setting, only if streaks

(select lower setting) or water stains

(select higher setting) are left on the

utensils.

1. Close the door.

2. Switch on ON/OFF switch (.

3. Press and hold down the START

button @.

4. Rotate programme selector 8

until : ... s indicated on the digital

display H.

5. Release button.

The factory set value :

the digital display H.

To change the setting:

1. Rotate programme selector 8 until

the required value is indicated on the

digital display H.

2. Press START button @.

The set value is saved.

Switching off rinse aid refill

indicator

If the rinse-aid refill indicator ` is

impaired (e.g. when using combined

detergents containing rinse aid

component), it can be switched off.

Proceed as described under "Setting

amount of rinse aid" and set the

value to :

The rinse aid refill indicator ` is now

switched off.

Rinse aid

is lit on