Siemens SX Series 사용 설명서 - 페이지 26

{카테고리_이름} Siemens SX Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SX Series 40 페이지. Dishwasher
Siemens SX Series에 대해서도 마찬가지입니다: 작동 지침 (38 페이지), 사용 설명서 (38 페이지), 사용 설명서 (42 페이지), 사용 설명서 (42 페이지), 사용 설명서 (44 페이지), 사용 설명서 (46 페이지), 사용 설명서 (44 페이지), 사용 설명서 (42 페이지), 사용 설명서 (48 페이지), 사용 설명서 (40 페이지), 사용 설명서 (42 페이지), 사용 설명서 (44 페이지)

페이지 인쇄
Siemens SX Series 사용 설명서
en
Fault, what to do?

Fault table

Fault
"Check water supply"
display )" lights up.
Error code :
is lit.
Error code :
is lit.
Error code :
is lit.
Error code :
is lit.
Error code :
is lit.
Error code :
is lit.
26
Cause
Supply hose kinked.
Tap turned off.
Tap jammed or calcified.
Filter in the water supply blocked. Switch off the appliance and pull out
Intake opening (on right inside of
appliance) covered by utensils.
Heating element calcified or
soiled.
Filters 1R are soiled or
blocked.
Waste water hose
is blocked or kinked.
Siphon connection still sealed.
Cover on the waste water pump
loose.
Waste water pump blocked
or cover on the waste water
pump is not locked in position.
Mains voltage too low.
Remedial action
Install supply hose without kinks.
Turn on the tap.
Turn on the tap.
Flow rate must be min. 10 l/min.
when water supply is open.
the mains plug. Turn off the tap. Unscrew
water connection.
Clean filter in the supply hose. Screw water
connection on again. Check for leaks.
Reconnect power supply. Switch on
the appliance.
Arrange utensils so that the intake opening
is not obstructed.
Clean appliance with dishwasher cleaning
agent or descaler. Operate the dishwasher
with water softening system and check the
setting (see chapter "Water softening
system/Special salt").
Clean filters.
(See Cleaning and maintenance)
Install hose without kinks, remove any
residue.
Check connection to siphon and open if
required.
Lock cover correctly.
(See Waste water pump)
Clean pump and lock cover correctly. (See
Waste water pump)
Not an appliance fault, have the mains
voltage and electrical installation checked.