Epson BrightLink 480i 설치 매뉴얼 - 페이지 5

{카테고리_이름} Epson BrightLink 480i에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson BrightLink 480i 5 페이지. Lamp and status information
Epson BrightLink 480i에 대해서도 마찬가지입니다: 여기에서 시작하기 매뉴얼 (6 페이지), 운영 매뉴얼 (47 페이지), 연결 매뉴얼 (6 페이지), 마운팅 템플릿 (5 페이지), 사양 (6 페이지), 적합성 선언 (4 페이지), 설치 핸드북 (3 페이지), 설치 핸드북 (2 페이지), 설치 핸드북 (5 페이지), 여기에서 시작하기 매뉴얼 (6 페이지)

(7) Determine the aspect ratio of the board or of the images that will be projected.

For new computers or laptops, this will most likely be WXGA (16:10). For older

equipment, this will most likely be XGA (4:3). You may need to consult your IT

director for this information.

___ 4:3 XGA

(8) Using the tables in the Installation Guide for your aspect ratio and desired image

height (h), find the required distance between the top of the image area and the

wall plate (c).

(9) Determine the position for your projector installation by adding the values for (f ),

(h), and (c), plus an additional 10 inches for the height of the wall plate plus the

cover.

If the ceiling height of your room (as noted in step 1) does not meet the

minimum ceiling height required for your board, you may need to select a

smaller image size or move the board to a lower position on the wall.

(10)After confirming your image size, use tape or a pencil to mark the distance (c)

from the top of the image area on the board to the bottom of the wall plate.

(11)Align the

line (horizontal) on the template sheet with the (c) mark, then align

the center line on the template sheet with the center of the image area. Follow

the instructions in the Installation Guide to install the projector.

___ 16:10 WXGA

___ 16:9 Widescreen

_____ (c)

_____ (f )

_____ (h)

_____ (c)

+10 inches

_____ total

CPD-37079