Siemens ED8 FS11E Series 사용 설명서 - 페이지 23

{카테고리_이름} Siemens ED8 FS11E Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens ED8 FS11E Series 36 페이지. Induction hob with integrated ventilation system

페이지 인쇄

[Energy consumption

indicator

T his function indicates the total amount of energy

E n e r g y c o n s u m p t i o n i n d i c a t o r

consumed by this hob the last time it was used for

cooking.

Once the hob is switched off, the energy consumption

is displayed in kilowatt hours (e.g.

10 seconds.

The accuracy of the information displayed depends on

the voltage quality of the mains power supply, among

other factors.

You can find out how to switch this function on in the

section on ~ "Basic settings"

kWh) for

‚

‹‰

Energy consumption indicator

tCookware check

T his function can be used to check the speed and

C o o k w a r e c h e c k

quality of the cooking process depending on the

cookware.

The result is a reference value and depends on the

properties of the cookware and the hotplate being used.

Correctly position the pot with approximately 200 ml

of water, at room temperature, on the most suitable

cooking zone for the diameter of the bottom of the

pot.

Go to the basic settings and select the setting

Press the programming area.

cooking zone displays.

The function has now been activated.

After 10 seconds, the cooking result and the speed of

the cooking process appear in the visual displays for

the cooking zone.

Check the result using the following table:

Result

The cookware is not suitable for the hotplate and will therefore

‹

not heat up.*

The cookware is taking longer to heat up than expected and the

‚

cooking process is not going as well as it should.*

The cookware is heating up correctly and the cooking process

is going well.

* If there is a smaller hotplate available, test the cookware again on the

smaller hotplate.

To reactivate this function, touch the settings range.

Notes

If the diameter of the hotplate used is much smaller

■

than the diameter of the cookware, only the middle

of the cookware can be expected to heat up. This

may result in the cooking results not being as good

as expected or being less than satisfactory.

You can find information on this function in the

■

section on ~ "Basic settings".

You can find information on the type, size and

■

positioning of the cookware in the section on

~ "Induction cooking".

™‚ ƒ

flashes in the