Siemens EH631BEB6E 사용 정보 - 페이지 10
{카테고리_이름} Siemens EH631BEB6E에 대한 사용 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens EH631BEB6E 16 페이지.
페이지 인쇄
en Cookware test
Display
Setting
Duration of the timer end signal tone
Power limitation
Enables the total power of the hob to be lim-
ited, if necessary, based on the conditions of
your electrical installation. The available set-
tings depend on the maximum power of the
hob. You can find precise information on the
rating plate. If the function is active and the
hob has reached the set power limit, is dis-
played and you cannot select a higher power
level.
Time for selecting the cooking zone
Cookware test
You can use this function to test the quality
of the cookware.
Restoring factory settings
Factory setting
1
10.2 To go to the basic settings
Requirement: The hob must be switched off.
To switch on the hob, touch
1.
Within the next 10 seconds, press and hold
2.
four seconds.
Product information
Directory for the technical after-sales
service (TK)
Production number
Production number 1
Production number 2
a The first four displays provide the product informa-
tion. Touch
or to view the individual displays.
11 Cookware test
The quality of the cookware has a major influence on
the speed and the result of the cooking process.
You can use this function to test the quality of the cook-
ware.
Before the test, ensure that the size of the cookware
base corresponds to the size of the cooking zone be-
ing used.
Access is via the basic settings. → Page 9
11.1 Carrying out Cookware test
At room temperature, place the cookware with ap-
1.
prox. 200 ml water in the centre of the cooking zone
that best fits the base of the cookware in terms of
size.
Call up the basic settings and select .
2.
10
.
for
Display
.
.
Value
1
– 10 seconds
– 30 seconds
- 1 minute
- Switched off. Maximum power of the hob
- 1000 W. Lowest power setting.
. - 1500 W.
...
- 3000 W. Recommended for 13 A.
. - 3500 W. Recommended for 16 A.
- 4000 W.
. - 4500 W. Recommended for 20 A.
...
- Maximum power of the hob.
- Unlimited: You can adjust the last selected cooking
zone without having to select it again.
– Limited: You can adjust the last selected cooking
zone within 10 seconds after selecting it. After this time,
you must select the cooking zone again before adjusting
it.
- Not suitable.
- Not optimal.
- Suitable.
1
- Individual settings
.
- Factory settings.
Touch
to access the basic settings.
3.
a
and light up alternately as well as as a preset
value.
Touch
repeatedly until the desired setting ap-
4.
pears.
Use
or
to select the required value.
5.
Touch and hold
6.
a The settings are saved.
10.3 Exiting the basic settings
To exit the basic settings and and switch off the
▶
hob, touch
.
Touch or . The
3.
zones.
a The function has been activated.
a After 10 seconds, the result appears in the cooking
zone displays.
11.2 Checking the result
You can see what the result means for the quality and
speed of the cooking process in the following table.
Result
The cookware is not suitable for the cooking zone
and therefore does not heat up.
1
.
1
for four seconds.
display flashes in the cooking