Siemens T68TS61N0 사용자 지침 - 페이지 9

{카테고리_이름} Siemens T68TS61N0에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens T68TS61N0 16 페이지.

If necessary, use a Torx screwdriver to adjust the

bypass screws:

A: For ULPG the bypass screws must be tightened

properly.

B: For Natural Gas the bypass screws must finish

flush with the fitting.

Make sure that the flame does not go out and that

there are no flashbacks when you turn the control

knob between the highest and lowest setting.

Never remove the gas tap axle. In the event of damage,

the gas valve must be completely replaced.

Getting to know your appliance

*Getting to know your

appliance

y o u r a p p l i a n c e

G e t t i n g t o k n o w

Pan supports

Control knobs

Economy burner with an output of up to 1 kW

Standard-output burner with an output of up to

1.75 kW

Mini wok burner up to 3.5 kW

Each control knob is marked with the burner it controls.

You can use the control knobs to set the output

required in each case to various positions between the

maximum and the minimum settings. Never try to switch

directly from position 0 to position 1 or from position 1

to position 0.

Indicators

Burner controlled by control knob

Switched-off burner

Highest power setting and electric ignition

Lowest power setting

It is essential to ensure that all the burner parts and pan

supports are correctly installed for the appliance to

work correctly. Do not swap the burner caps around.

Always remove the pan supports carefully. When

moving a pan support, the pan supports next to it may

also move.