Epson ChromaBlast 1.0 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Epson ChromaBlast 1.0에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson ChromaBlast 1.0 13 페이지. For epson stylus pro 4880
Epson ChromaBlast 1.0에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (47 페이지)

페이지 인쇄

Changing Menu Settings

You can use the buttons on the projector or remote control to

display the menus and change settings.

1. Press the

button on the projector or remote control.

You see a screen similar to the one below (the screen you see

depends on the equipment you've connected):

The four menus are shown on the left, and the options

available to the highlighted menu are shown on the right.

Note: If nothing is connected to the projector, some options

may not be available.

2. Press the up or down arrow button on the remote control or

the

button on the projector's control panel to

move to the menu you want. When your menu is

highlighted, press the

Select

the selected menu on the right. The highlight moves to the

first option on the list.

3. Press the up or down arrow button on the remote control or

the

button on the projector's control panel to

move through the list of options. When the option you want

to change is highlighted, press the

You may see a list of settings, a submenu providing

additional options, or a line menu or slider bar similar to the

one below:

4. If you see a list of settings, use the arrow buttons on the

remote control or the

control panel to move to the setting you want, then press the

button. Enabled settings are indicated by a green

Select

light, while disabled ones are gray.

If an option has a submenu, press the

display it, then select the setting you want.

button. You see the options for

button.

Select

button on the projector's

button to

Select

EPSON PowerLite Home 10 Projector

If you see a line menu or slider bar, press the left or right

arrow button on the remote control, or the

on the projector to change the setting.

5. Press the

button to return to the previous menu.

Esc

6. Press the

button to exit the menu system.

Replacing the Remote Control Battery

When the battery in the remote control runs out, follow the

steps below to replace it. You'll need a CR2025 lithium battery,

which you can obtain commercially.

1. Press the catch in as you pull the battery holder out

Press here and slide

out battery holder

2. Remove the old battery and insert the new one. Make sure

the

side of the battery is facing up, as shown.

Old battery

3. Slide the battery holder back

into the remote control until it

clicks into place.

Caution:

When replacing the battery, follow these guidelines:

❑ Replace the battery as soon as it runs out.

❑ If the battery leaks, wipe away battery fluid with a soft cloth. If

fluid gets on your hands, wash them immediately.

❑ Remove the battery if you will not be using the remote for a

long period of time.

❑ Dispose of the used battery in accordance with local

regulations.

7/03

EPSON PowerLite Home 10 Projector - 9

button

New battery