Cisco 7962G - Unified IP Phone VoIP 관리 매뉴얼 - 페이지 14

{카테고리_이름} Cisco 7962G - Unified IP Phone VoIP에 대한 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7962G - Unified IP Phone VoIP 16 페이지. Unified communications manager 9.0 (sccp and sip)
Cisco 7962G - Unified IP Phone VoIP에 대해서도 마찬가지입니다: 사용자 설명서 (23 페이지), 데이터시트 (5 페이지), 사용자 설명서 (6 페이지), 사용자 설명서 (4 페이지), 사양 (5 페이지), 관리 매뉴얼 (12 페이지), 사용자 설명서 (13 페이지), 사용자 설명서 (12 페이지), 빠른 참조 매뉴얼 (2 페이지), 사용자 설명서 (6 페이지), 문제 해결 및 유지 관리 (27 페이지)

Phone Startup Process Verification

After the Cisco Unified IP Phone has power connected to it, the phone begins its startup process by cycling

through the following steps.

1 These buttons flash on and off in sequence:

2 Some or all of the line keys flash amber in sequence.

Caution

If the line keys flash red in sequence after flashing amber, do not power down the phone until the sequence

of red flashes completes. This sequence can take several minutes to complete.

3 Some or all of the line keys flash green.

Normally, this sequence takes just a few seconds. However, if the phone's Flash memory is erased or the

phone load is corrupted, the sequence of green flashes will continue while the phone begins a software

update procedure. If the phone performs this procedure, the following buttons light to indicate progress:

4 The phone screen displays the Cisco Systems, Inc., logo screen.

5 These messages appear as the phone starts:

6 The phone screen displays:

Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco

Unified Communications Manager 9.0 (SCCP and SIP)

• Headset (only if the handset is off-hook when the phone powers up. Hang up the handset within 3

seconds to have the phone launch its secondary load. To continue with the primary load, leave the

handset off-hook.)

• Mute

• Speaker

• Headset—Phone is waiting for the network and completing CDP and DHCP configuration. A DHCP

server must be available in your network.

• Mute—Phone is downloading images from the TFTP server.

• Speaker—Phone is writing images to its Flash memory.

• Verifying Load (if the phone load does not match the load on the TFTP server). If this message

appears, the phone starts up again and repeats step 1 through step 4 above.

• Configuring IP

• Updating the Trust List

• Updating Locale

• Configuring Unified CM List

• Registering

• Current date and time

• Primary directory number

Cisco Unified IP Phones Installation