Cisco 7970 Series 설정 - 페이지 3

{카테고리_이름} Cisco 7970 Series에 대한 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7970 Series 15 페이지. Unified ip phone
Cisco 7970 Series에 대해서도 마찬가지입니다: 빠른 참조 (2 페이지), 전화 매뉴얼 (45 페이지)

페이지 인쇄
Cisco 7970 Series 설정
Chapter 3
Setting Up the Cisco IP Phone

Network and Access Ports

Handset
Speakerphone
OL-4314-01
In Cisco CallManager, you can add users to the database and associate them with
specific phones. In this way, users gain access to web pages that allow them to
configure items such as call forwarding, speed dialing, and voice messaging
system options. See the
page 5-7
for details.
The back of the Cisco IP Phone 7970 has a network port, labeled 10/100 SW, and
an access port, labeled 10/100 PC. Each port supports 10/100 Mbps half- or
full-duplex connections to external devices. You can use either Category 3 or 5
cabling for 10-Mbps connections, but you must use Category 5 for 100 Mbps
connections.
Use the 10/100 SW network port to connect the phone to the network. You must
use a straight-through cable on this port. The phone can also obtain inline power
from a switch over this connection. See the
Cisco IP Phone 7970" section on page 2-4
Use the 10/100 PC access port to connect a network device, such as a computer,
to the phone. You must use a straight-through cable on this port.
The handset is designed especially for use with a Cisco IP Phone. It includes a
light strip that indicates incoming calls and voice messages waiting.
By default, the speakerphone is enabled on Cisco IP Phone 7970. You can disable
the speakerphone through the Cisco CallManager Administration application or
from the phone itself.
To disable the speakerphone from Cisco CallManager, choose Device > Phone
and locate the phone you want to modify. In the Phone Configuration web page
for the phone, check the Disable Speakerphone check box.
Cisco IP Phone 7970 Administration Guide for Cisco CallManager 3.3
"Adding Users to Cisco CallManager" section on
"Providing Power to the
for details.
Before You Begin
3-3