Cisco 7970G - IP Phone VoIP 문제 해결 및 유지 관리 - 페이지 22

{카테고리_이름} Cisco 7970G - IP Phone VoIP에 대한 문제 해결 및 유지 관리을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7970G - IP Phone VoIP 25 페이지. Unified ip phones
Cisco 7970G - IP Phone VoIP에 대해서도 마찬가지입니다: 사용자 설명서 (21 페이지), 설치 준비 (17 페이지), 설치 매뉴얼 (19 페이지)

페이지 인쇄

Cisco 7970G - IP Phone VoIP 문제 해결 및 유지 관리

Maintenance

This section contains the following topics

Quality Report Tool

The Quality Report Tool (QRT) is a voice quality and general problem-reporting tool for the Cisco Unified IP

Phone. The QRT feature is installed as part of the Cisco Unified Communications Manager installation.

You can configure Cisco Unified IP Phones with QRT. When you do so, users can report problems with phone

calls pressing QRT. This softkey is available only when the Cisco Unified IP Phone is in the Connected,

Connected Conference, Connected Transfer, or OnHook states.

When a user presses QRT, a list of problem categories appears. The user selects the appropriate problem

category, and this feedback is logged in an XML file. Actual information logged depends on the user selection,

and if the destination device is a Cisco Unified IP Phone.

For more information about using QRT, see the Cisco Unified Serviceability Administration Guide.

Voice Quality Monitoring

To measure the voice quality of calls that are sent and received within the network, Cisco Unified IP Phones

use these statistical metrics based on concealment events. The Digital Signal Processor (DSP) plays concealment

frames to mask frame loss in the voice packet stream.

• Concealment Ratio metrics: Show the ratio of concealment frames over total speech frames. An interval

• Concealed Second metrics: Show the number of seconds in which the DSP plays concealment frames

• MOS-LQK metrics: Use a numeric score to estimate the relative voice listening quality. The Cisco Unified

Note

Concealment ratio and concealment seconds are primary measurements based on frame loss while MOS LQK

scores project a "human-weighted" version of the same information on a scale from 5 (excellent) to 1 (bad)

for measuring listening quality.

Troubleshooting and Maintenance

conceal ratio is calculated every 3 seconds.

due to lost frames. A severely "concealed second" is a second in which the DSP plays more than five

percent concealment frames.

IP Phone calculates the mean opinion score (MOS) for listening quality (LQK) based audible concealment

events due to frame loss in the preceding 8 seconds, and includes perceptual weighting factors such as

codec type and frame size.

MOS LQK scores are produced by a Cisco proprietary algorithm, Cisco Voice Transmission Quality

(CVTQ) index. Depending on the MOS LQK version number, these scores might be compliant with the

International Telecommunications Union (ITU) standard P.564. This standard defines evaluation methods

and performance accuracy targets that predict listening quality scores based on observation of actual

network impairment.

Troubleshooting and Maintenance