Cisco 8000 Series 설치 준비 - 페이지 5

{카테고리_이름} Cisco 8000 Series에 대한 설치 준비을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 8000 Series 10 페이지. Ip phones with multiplatform firmware
Cisco 8000 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (39 페이지)

페이지 인쇄

Prepare for Installation

• When mounting the chassis in a partially filled rack, load the rack from the bottom to the top with the

• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the

• Airflow around the chassis and through the vents is unrestricted.

• Cabling is away from sources of electrical noise, such as radios, power lines, and fluorescent lighting

• Each port must match the wave-length specifications on each end of the cable, and the cable must not

Note

Cisco 8000 Series Routers function in operating temperatures of up to 40 degrees C at sea level. For every

300 meters (1000 feet) elevation, the maximum temperature is reduced by 1 degrees C. For more details on

environmental requirements, see

Note

When the Cisco 8200 Series Routers use port side exhaust fans and power supplies, the maximum temperature

is reduced by 5 degrees C (for example, 35 degrees C at sea level or 30 degrees C at 1500 meters).

Procure Tools and Equipment

Obtain these necessary tools and equipment for installing the chassis:

• Number 1 and number 2 Phillips screwdrivers with torque capability to rack-mount the chassis.

• 3/16-inch flat-blade screwdriver.

• Tape measure and level.

• ESD wrist strap or other grounding device.

• Antistatic mat or antistatic foam.

• Two-hole ground lug (1).

• Pair of mounting brackets.

• Grounding cable (2 AWG recommended), sized according to local and national installation requirements;

• A crimping tool specified by the lug manufacturer that is large enough to accommodate the girth of the

• Wire-stripping tool.

• A maximum of 70 rack mount screws can be used based on your rack selection.

heaviest component at the bottom of the rack.

chassis in the rack.

fixtures. Make sure that the cabling is safely away from other devices that might damage the cables.

exceed the stipulated cable length.

the required length depends on the proximity of the switch to proper grounding facilities.

lug.

Cisco 8000 Series Routers Data

Procure Tools and Equipment

Sheet.

Prepare for Installation