Epson EasyMP Monitor 4.50 운영 매뉴얼 - 페이지 5
{카테고리_이름} Epson EasyMP Monitor 4.50에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson EasyMP Monitor 4.50 11 페이지. Operation guide - easymp monitor v4.50
Epson EasyMP Monitor 4.50에 대해서도 마찬가지입니다: 운영 매뉴얼 (47 페이지)
페이지 인쇄
The Epson BrightLink 450/455 models are nearly identical in design and function. The following
guide provides instruction for the basic operations as well as troubleshooting measures of these devices.
Connecting to a computer/document camera
•
Projectors are connected to classroom computer via VGA and USB cables.
a. Projectors have two points of connection: Face plate at computer, Faceplate at
projector.
•
VGA cables transfer video only. Wall plate at computer (VGA w/ audio) will likely have an audio
connection and will need an audio cable to transfer sound to the projector.
•
USB cable allows interactive function of pens. USB cable must be connected at wall face plate at
computer and projector. (Interactive Tools Driver should/must be downloaded to the user
computer via Software Center.
a. Interactive Pen Calibration: Epson Interactive Pens will occasionally need to be
calibrated. On the 450 and 455 projectors, the use must access the calibration menu
from the Epson Interactive Driver installed on the computer. Without this driver, the
pens will not be able to be calibrated so make sure the driver is installed.
i. Ensure pens have good batteries.
ii. Locate Interactive Driver Icon (Lower right corner of computer screen.
iii. Select "Calibrate (Normal).
iv. Tap the pen on each dot.
v. Continue until all dots are black.
Projector Connections
Epson BrightLink 450/455
Epson 450/455
Drivers)