Registering and deleting projectors for monitoring
Make the necessary settings while referring to the following table.
Display name
Enter the name of the projector(s) to be displayed in
Grouping view or Detail list view.
Up to a maximum of 32 bytes can be entered. A space
cannot be used as the first character.
Display icon
Select the icon(s) to be displayed in Grouping view or
Detail list view.
Select when registering a projector in a group.
Parent group
If no groups have been created, this cannot be selected.
s "Registering several projectors to a monitoring
group all at once"
p.16
This shows the name that has been registered on the
Projector name
projector.
IP address
This shows the IP address for the registered projector.
This cannot be selected when registering projectors
Use Serial W
using automatic search.
TCP/IP conver-
sion adaptor.
Port Number
This cannot be selected when registering projectors
using automatic search.
If a Monitor Password has been set for the projector,
Monitor Pass-
be sure to enter the Monitor Password that has been
word
set. If the correct password is not entered at this time,
it will not be possible to monitor and control the
projector even though it is registered.
Description
You can enter some kind of memo about the projector.
The details you enter here will be displayed at the
projector properties.
Up to a maximum of 60 bytes can be entered.
Monitor
Select this when you want monitoring to start.
B
After entering the details, click "Register" to start the
registration. When the message is displayed, click "OK".
To continue registering other projector(s), repeat Steps 1 and 2.
Projectors that have been registered using automatic search are
q
searched for again by projector name each time EasyMP Monitor
is started.
12
페이지 인쇄