Two Connection Modes
Preparing to Connect
Follow the steps below to connect the computer and the projector via a
network using EasyMP Network Projection.
a
Install EasyMP Network Projection on the computer to be
connected.
"Installing"
p.7
s
b
Make network settings on the computer and put it into network
connection status.
See the documentation supplied with your the computer, wireless
LAN adapter, or AirMac card for details on network settings.
a
When the computer you are using is normally connected to the
network, you do not need to make network settings on the
computer.
c
For Quick Connection Mode
Install the Wireless LAN unit to the projector (If already installed, go
to step 5).
For Advanced Connection Mode
Enable the wireless LAN adaptor at Port Configurations.
Computer's documentation
s
d
Make network settings on the projector and put it into network
connection status.
You can make network settings from the projector's Network menu.
See the following manual for details.
User's Guide "Network Menu (EB-1775W/EB-1770W/EB-1760W
s
Only)"
e
Press the [LAN] button on the remote control.
The LAN standby screen is displayed.
If there is no signal for the current input source, it automatically
switches to the LAN source. If it does not automatically switch to the
LAN source, press the [LAN] button.
f
Start EasyMP Network Projection on the computer and connect
with the projector.
"Connecting to a Projector on a Network and Projecting"
s
p.11
a
If a connection error occurs, a number indicating the type of error is
displayed as follows.
Event ID: 04xx
See the following manual for details on Event ID.
User's Guide "About Event ID (EB-1775W/EB-1770W/EB-1760W
s
Only)"
10
페이지 인쇄