Connecting to a Projector on a Different Subnet
You can connect the projector and the computer and project to screens at
remote locations (on different subnets).
In Automatic search, projectors on different subnets are not found because
searches are only performed on the same subnet.
You can use the following methods to connect to a projector on a different
subnet.
• Specify either an IP address or projector name and perform a search.
The IP address can be input directly. Also, provided the projector name
to be connected has been registered on the DNS server, you can perform
a search simply by inputting that projector name.
"Specifying Either an IP Address or Projector Name and Performing a
s
Search (Advanced Connection Mode Only)"
• Perform a search based on a profile.
Once you have performed a search for a projector on a different subnet
by specifying either an IP address or a projector name, you can save the
search as a profile with an easy-to-remember name, and then use that
profile whenever you subsequently want to search for a projector on a
different subnet.
"Performing a Search with a Profile"
s
a
• If you cannot find a projector, see the following section for the most
likely causes.
s "Troubleshooting"
• When you use Manual search in Quick Connection Mode, you can
specify the SSID. When there are a lot of projectors you can narrow
the search field by using SSID.
p.16
p.17
p.38
Specifying Either an IP Address or Projector Name
and Performing a Search (Advanced Connection
Mode Only)
In the following explanations, unless otherwise noted, Windows screen
shots are used.
Similar screens are displayed on Mac OS.
a
Click Manual search on the EasyMP Network Projection projector
selection screen.
b
Enter the IP address or the projector name for the projector you
want to connect to, and click OK.
16
페이지 인쇄