Cisco 8865 매뉴얼 - 페이지 8

{카테고리_이름} Cisco 8865에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 8865 48 페이지. Multiplatform phones
Cisco 8865에 대해서도 마찬가지입니다: 특징 (16 페이지), 사용자 설명서 (24 페이지), 사용자 설명서 (28 페이지), 펌웨어 마이그레이션 마스터 매뉴얼 (31 페이지), 사용자 설명서 (30 페이지), 사용자 설명서 (23 페이지), 매뉴얼 (44 페이지), 매뉴얼 (43 페이지), 매뉴얼 (14 페이지), 설치 매뉴얼 (39 페이지), 재구성 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 사용자 설명서 (13 페이지), 빠른 시작 매뉴얼 (2 페이지), 사용자 설명서 (8 페이지), 매뉴얼 (11 페이지), 사용자 설명서 (40 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄
Cisco 8865 매뉴얼
Charge Cisco Headset 561 and 562
Number
Name
2
Mute button
3
Volume button (
4
LED
Charge Cisco Headset 561 and 562
Use the headset base to charge the headset.
Procedure
Place the headset into the socket on the base.
The LEDs on the base station indicate the charging status. When the headset is fully charged, the five LEDs
on the base are steady white. If the LEDs don't light up, remove the headset from the base and try again.
Third Party Headsets
Cisco Systems performs internal testing of third-party headsets for use with Cisco IP Phones. But Cisco does
not certify or support products from headset or handset vendors.
Headsets connect to your phone using either the USB or the auxiliary port. Depending upon your headset
model, you have to adjust your phone's audio settings for the best audio experience, including the headset
sidetone setting.
If you have a third-party headset, and you apply a new sidetone setting, then wait one minute and reboot the
phone so the setting is stored in flash.
The phone reduces some background noise that a headset microphone detects. You can use a noise canceling
headset to further reduce the background noise and improve the overall audio quality.
If you are considering a third-party headset, we recommend the use of good quality external devices; for
example, headsets that are screened against unwanted radio frequency (RF) and audio frequency (AF) signals.
Cisco IP Phone Accessories
8
Description
Toggle the microphone on and off. When Mute on the headset is enabled:
• The Mute
• The Mute
only)
Adjust the volume on your headset.
and
)
Shows the headset status:
• Blinking red—Incoming call.
• Steady red—Active call.
• Flashing white every 6 seconds—The headset is paired and idle.
• Blinking white—Firmware upgrade is in process or the headset is
pairing with the base station.
button on the phone lights up.
button on the headset base lights up. (For Multibase
Cisco IP Phone Accessories