Digital Lumens DLA-R 설치 지침 매뉴얼 - 페이지 8
{카테고리_이름} Digital Lumens DLA-R에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Lumens DLA-R 8 페이지.
페이지 인쇄Step Three: Update the Sticker Book
Guidelines
• Each DLA comes with an extra metallic serial number label.
• It is critical that you adhere the label to the sticker book, which represents the facility's
floor plan. Place the label in the box that corresponds to the relative location of the DLA
within the facility.
• Note that without an accurate and complete sticker book, the facility's lighting management
software cannot be programmed and the installation process may be delayed.
• The project manager will provide access to the sticker book.
Step Four: Verify DLA Hardware
Locate Hear tbeat
Once the fully installed DLA unit, including adapter and sensor, is powered ON, you can verify that the equipment is receiving
power by locating the DLA heartbeat. Look at the sensor lens: Every 30 seconds, you should see a blinking red LED indicator.
Note that until the DLA unit is programmed using Commissioner software, the DLA unit will use the following settings, which
effectively tell the connected light fixture(s) to remain ON at 100%, with no occupancy sensing:
• Active Light Level: 100%
• Inactive Light Level: 100%
• Occupancy Sensor Delay: Sensor Inactive
www.digitallumens.com
374 Congress Street, Suite 600
Boston, MA USA 02210
+1 (617) 723-1200
Heartbeat Indicator
Blank page from a sticker book
created using a CAD program
All Rights Reser ved © 2010-2015
Digital Lumens Incorporated
Subject to change without notice.
DOC-000390-00 Rev A 10-15