Digital Lumens DLA-S 설치 지침 매뉴얼

{카테고리_이름} Digital Lumens DLA-S에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Lumens DLA-S 8 페이지.

DLA Sensor

INSTALLATION INSTRUCTIONS

PRODUCT SAFETY

Digital Light Agent

familiar with the construction and operation of the product and the hazards involved.

To avoid risk of electrical shock, disconnect power before installing, wiring, or servicing DLA hardware.

D o not use fixture or DLA hardware if the housing, sensor optic or wires are damaged.

Do not apply paint, lubricants or other coatings to the DLA housing.

Use a dry cloth to clean the DLA housing and sensor optic.

OVERVIEW

The DLA system transforms fixtures from third-party manufacturers into an intelligent light with high-performance sensors, power

metering, full-range dimming, and software optimization capabilities.

There are two categories of DLA components: DLA sensors and DLA adapters.

• DLA sensors measure occupancy and ambient light. They also control connected fixtures through a direct link with Philips SR

(Sensor Ready) drivers, DALI drivers, or through 0-10 V adapters (for older 0-10 V LED drivers). DLA sensors communicate

wirelessly with the LightRules system to receive commands and send data.

• DLA adapters measure fixture power consumption. They also convert the digital commands from DLA sensors into an analog

0-10 V signal for use with 0-10 V dimming LED drivers.

Note that this document covers DLA sensors. Please refer to the DLA Adapter Installation Instructions for adapter setup.

SENSOR TYPES

DLA-R (Recessed Mount)

Use the DLA-R when you want to blend the sensor into an environment by mounting flush to a junction box or

a ceiling tile.

DLA-E (Philips EvoKit)

The DLA-E is designed to install in the mounting slot of the Philips EvoKit SR retrofit kit.

DLA-S (Sur face Mount)

Featuring an IP65 rating, use the DLA-S in challenging environments. DLA-S mounts to a ceiling surface or

NEMA 4 or weatherproof junction box.

DLA-I (Integrated Mount)

The DLA-I mounts directly to into any third-party fixture — the housing mounts inside and the lens assembly

extends externally.

HELPFUL HINTS

• Install the DLA sensor in a manner so as to provide a clear field of view for the lens.

• Do not mount the DLA sensor within 5 ft (1.5 m) of an air vent.

• Consult the DLA specification sheets for detail regarding mounting heights and occupancy sensor coverage patterns.

(DLA) hardware must be installed in accordance with the applicable installation code by a person

™