Cisco Cisco Unified IP Phone 7960G 관리자 매뉴얼 - 페이지 11

{카테고리_이름} Cisco Cisco Unified IP Phone 7960G에 대한 관리자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Cisco Unified IP Phone 7960G 15 페이지. Ios telephony services ip phone
Cisco Cisco Unified IP Phone 7960G에 대해서도 마찬가지입니다: 사용자 설명서 (21 페이지), 사용자 설명서 (25 페이지), 빠른 참조 (2 페이지), 빠른 참조 매뉴얼 (2 페이지), 사용자 설명서 (20 페이지), 사용자 설명서 (28 페이지), 전화 매뉴얼 (17 페이지), 설치 매뉴얼 (12 페이지), 사용자 설명서 (16 페이지), 참조 매뉴얼 (24 페이지), 관리 매뉴얼 (29 페이지), 매뉴얼 (21 페이지), 사용자 설명서 (10 페이지)

페이지 인쇄
Cisco Cisco Unified IP Phone 7960G 관리자 매뉴얼
Chapter 1
Product Overview
Figure 1-3
Power
outlet
(optional power

Connecting to the Network

The Cisco SIP IP phone has two RJ-45 ports that each support 10/100 Mbps half- or full-duplex Ethernet
connections to external devices—network port (labeled 10/100 SW) and access port (labeled 10/100
PC). You can use either Category 3 or 5 cabling for 10 Mpbs connections, but use Category 5 for 100
Mbps connections. On both the network port and access port, use full-duplex mode to avoid collisions.
Network Port (10/100 SW)
Use the network port to connect the phone to the network. You must use a straight-through cable on this
port. The phone can also obtain inline power from the Catalyst switch over this connection. See the
"Connecting to Power" section on page 1-11
Access Port (10/100 PC)
Use the access port to connect a network device, such as a computer, to the phone. You must use a
straight-through cable on this port.

Connecting to Power

The Cisco SIP IP phone can be powered by the following sources:
•
OL-2206-01
Cisco SIP IP Phone Cable Connections
Cisco IP phone (rear view)
cable)
RS-232 port
External power source—Optional Cisco AC adapter and power cord for connecting to a standard
wall receptacle.
Network port
Access port
(10/100 SW)
(10/100 PC)
for details.
Cisco SIP IP Phone Administrator Guide Version 3.0
Cisco SIP IP Phone Connections
Headset
port
Handset
port
1-11