3Com SuperStack II Switch 1100 빠른 설치 매뉴얼 - 페이지 2
{카테고리_이름} 3Com SuperStack II Switch 1100에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com SuperStack II Switch 1100 6 페이지. Atm expansion module
페이지 인쇄
2
C
: Q
I
HAPTER
UICK
NSTALLATION
Warning: Disconnect the Switch from the network,
power it off and then disconnect the Switch from the
main power supply.
Step 1:
Remove the blank plate that is located at the back of
the SuperStack II Switch, by unscrewing the two Phil-
lips screws as shown in Figure 1.
Retain the blank plate and the screws for future use.
Figure 1 Removing the Blank Plate
Blank Plate
G
S
S
II S
1100/3300 ATM E
UIDE FOR THE
UPER
TACK
WITCH
M
XPANSION
ODULE
Step 2:
Hold the module with the cutout on your front left
side,without touching the top or bottom of the circuit
board. Use the guide rails within the switch slot to
align the ATM Expansion Module as shown in
Figure 2.
Slide the ATM Expansion Module into the slot. Ensure
that the module is fully engaged to the switch. You
should hear a click.
Figure 2 Aligning and Inserting the ATM Expansion Module
Cutout