Ricoh SP 311DNW 시작하기 매뉴얼 - 페이지 37
{카테고리_이름} Ricoh SP 311DNW에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh SP 311DNW 45 페이지. Network settings guide
Ricoh SP 311DNW에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (2 페이지), 사양 (4 페이지), 설치 매뉴얼 (2 페이지)
페이지 인쇄
Connection Succeeded: If the Power indicator lights, the connection between the printer
•
and router was successful.
Connection Failed: If all indicators flash simultaneously, and after 30
•
seconds only the Power indicator lights, the connection failed. Check
that the router is properly configured and try again.
Important:
If you are configuring the printer again, e.g., you have changed the device's location, use the
•
following method to reset the printer to factory defaults, and then repeat steps 1-2.
Factory Defaults: Hold down [Job Reset] and [Stop/Start] keys, and then turn machine On. When
Alert indicator (middle LED) starts flashing, release keys. Turn printer power switch Off, and then On.
5. Next, install Printer Driver and Utility. See
Manual Method
If your router doesn't support WPS, for instance older routers, there are two ways to manually configure
wireless LAN settings, using the bundled Smart Organizing Monitor utility or the embedded
Monitor
utility.
Using Smart Organizing Monitor
Smart Organizing Monitor enables you to view and change printer settings, check supply levels, etc. from
your computer, as well as print
Before proceeding, please check the following:
Wireless router is working correctly, e.g., you can wirelessly connect to the Internet from your laptop.
•
Printer power switch is On.
•
Printer is connected to network (via Ethernet cable).
•
Printer's
IP address
is available.
•
Smart Organizing Monitor utility is installed. See
•
To configure wireless settings manually, using Smart Organizing Monitor, proceed as follows:
1. Click [Start]
[Smart Organizing Monitor Status].
RICOH SP 311DNw B&W Network Laser Printer
3.2 Network Quick
configuration
and
test
pages.
3.2 Network Quick
Getting Started Guide
Install.
Install.
Web Image
37