ActronAir LR7-1W 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} ActronAir LR7-1W에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ActronAir LR7-1W 8 페이지.

Installation Guide

01. Safety Precautions .................................................................................................2

02. Specifications ........................................................................................................2

03. Installation ............................................................................................................3

04. Wiring Diagram ......................................................................................................4

04.01. Single Wall Control to Indoor Board .................................................................. 4

04.02. Multiple Wall Control ......................................................................................... 4

05. Controller Assignment ...........................................................................................5

06. Sensor Enable/Calibration ......................................................................................5

07. Enabling Zones and Assigning Sensors ...................................................................6

08. Minimum and Maximum Zone Positions .................................................................6

09.01. Initiating Self-Learn Mode ................................................................................. 7

1. Read all instructions in this manual before operating the air conditioning unit. Failure to do so may result in damage

to the unit and void your warranty.

2. Turn off the power supply to the unit and follow necessary LOCK-OUT/TAG-OUT (LOTO) procedures to ensure that

power supply is not re-energised accidentally.

3. This control interface is connected to the wall control terminal block on the Indoor board via screwed terminals and

Cat5e UTP (AWG24) Data Cable. Ensure that this unit is not installed on voltages other than specified.

4. Make sure that the unit installation complies with all relevant council regulations and building code standards. All

electrical wiring must be in accordance with current electrical authority regulations and all wiring connections must

follow the electrical diagram provided.

5. WH&S rules and regulations must be observed and will take precedence during installation process.

6. Only use this Control Interface with an ActronAir air conditioner as described in this installation guide.

• Voltage: 12VDC +/- 10% (LR7 control connects directly to the Indoor board)

• Data: Cat5e UTP (AWG24) Data Cable, Maximum Cable Length up to 100m

• Operating conditions: -10 to 60OC, < 90% RH non-condensing

• Storage conditions: -20 to 70OC, < 90% RH non-condensing

NOTE

Do not use ActronAir 4 Core Data Cable Part Numbers: 4070-003/AMDC4 or Non-Twisted Pair multi core cable.

LR7 Control Interface Insert

Doc. No. 9590-3019 Ver. 3 200702

LR7 Control Interface

Table of Contents