Ricoh L5160 CIP 교육 - 페이지 4

{카테고리_이름} Ricoh L5160에 대한 CIP 교육을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh L5160 36 페이지.
Ricoh L5160에 대해서도 마찬가지입니다: 교육 (29 페이지), CIP 교육 (28 페이지), CIP 교육 (17 페이지), CIP 교육 (28 페이지)

페이지 인쇄

CIP Training L5160/L5130

Basic Operation

Adjusting the Heater Temperature

Set the heater temperature to meet the characteristics of the media. Set the

temperature of the pre-heater, print heater, post-heater, and cure heater

according to the type and characteristics of the media used. Automatic

temperature setting can be made on the operation panel by setting the profile on

the dedicated RIP. For setting on the RIP, see the instruction manual for your RIP.

Do not leave the media with the heater ON for a long time.

This section explains how to check and change the temperature of the pre-heater, print heater,

post-heater, and cure heater.

Set the temperature of each heater depending on the media to be used. It takes several minutes

or hours to reach the configured temperature depending on the operating environment.

1. Check the temperature of each heater on the home screen.

For details about how to check the temperature, see "Checking the state of the heater".

Press [Heater Setting].

Select the [On] check box when enabling the heater.

Press [All On] or [All Off] to enable or disable the pre-heater, print heater,

post-heater, and cure heater collectively.

4. Press [ ]

[

] to set the temperature of each heater.

(mainly Europe and Asia)

• Press

All +5°C

print heater, post-heater, and cure heater collectively. The temperature of

each heater can be set between 20 to 70°C or 20 to 95°C.

All -5°C] to change the temperature of the pre-heater,