Ricoh P311 설정 매뉴얼 - 페이지 10

{카테고리_이름} Ricoh P311에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh P311 24 페이지.
Ricoh P311에 대해서도 마찬가지입니다: 사용 설명서 (32 페이지)

페이지 인쇄
Ricoh P311 설정 매뉴얼
Connecting the Machine via Wireless (Wi-Fi)
Easy Setup Using the Wi-Fi Setup Wizard
From the control panel of this machine, you can also configure the
Wireless (Wi-Fi) settings for the machine.
The following item is necessary to set up a Wireless
(Wi-Fi) connection.
● Router (access point)
Checking the SSID and Encryption key
The SSID and Encryption key for the router (access point) may be
printed on a label affixed to the router (access point). For details
about the SSID and Encryption key, refer to the router (access point)
manual.
Confirm the SSID and Encryption key, and write them down on the
blank space as shown below.
SSID:
Encryption key:
Configuring Settings Using the Control Panel
● Make sure the Ethernet cable is not connected to the
machine.
™
M 320FB/320F
1.
Check that the router (access point) is working correctly.
2.
Make sure the wireless LAN option is attached to the
machine and the wireless (Wi-Fi) connection is enabled.
For details, see page 6 "Attaching the wireless LAN option".
3.
Press [Quick Setup].
For details about [Detailed Setup], see User's Guide.
8
SSID
:XXXXXXXXXXXXX
Encryption key
:XXXXXXXXXXXXX
DSG099
ECC292
DYG155
4.
Press [Change Wi-Fi Connection Mode].
5.
Press [Setup Wizard].
6.
Press the SSID of the router (access point) from the
searched SSID list.
7.
Enter the encryption key using the number keys, and then
press [Connect].
• As the passphrase, you can enter either 8 to 63 ASCII characters
(0x20-0x7e) or 64 hexadecimal digits (0-9, A-F, a-f).
• For details about checking the encryption key, see "Checking the
SSID and Encryption key".
8.
Check the result.
Connection has succeeded:
"Connected to access point." is displayed.
Connection has failed:
"Failed to connect to access point." is displayed.
Check the configuration for the router (access point), and then try the
connection again.
9.
Press [OK].
10. Configuring the Wireless (Wi-Fi) settings is complete.
To use the fax function, configure the settings on page
16 "3. FAX Settings (M 320FB/320F only)".
ECC293